Dell D08S owner manual Installing the Speaker, Memory Module Guidelines

Page 19

Installing the Speaker

1.Place the speaker at the appropriate location on the chassis.

2.Press the speaker-securing tab and slide the speaker towards the left of the computer to secure it.

3.Guide the speaker cable through the securing tab and connect the speaker cable to the system board.

4.Install the:

a)drive cage

b)optical drive

c)cover

5.Follow the procedures in After Working Inside Your Computer.

Memory Module Guidelines

To ensure optimal performance of your computer, observe the following general guidelines when configuring your system memory:

Memory modules of different sizes can be mixed (for example, 2 GB and 4 GB). But, all populated channels must have identical configurations.

Memory modules must be installed beginning with the first socket.

NOTE: The memory sockets in your computer may be labeled differently depending on the hardware configuration. For example, A1, A2 or 1,2,3.

If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be installed in the sockets with the white release levers.

If memory modules with different speeds are installed, they operate at the speed of the slowest installed memory modules.

19

Image 19
Contents Regulatory Model D08S Regulatory Type D08S001 Page Contents Diagnostics Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerPage Page Recommended Tools Removing and Installing ComponentsSystem Overview Removing the Cover Installing the Cover Removing the Front Bezel Installing the Front BezelRemoving The Expansion Card Page Removing the Optical Drive Installing The Expansion CardRemoving the Drive Cage Installing the Optical DriveInstalling the Drive Cage Removing the Hard Drive Removing the Speaker Installing the Hard DriveMemory Module Guidelines Installing the SpeakerRemoving the Memory Installing the MemoryRemoving the System Fan Removing the Power Switch Installing the System FanInstalling the Power Switch Removing the I/O Panel Removing the Power Supply Installing the I/O PanelPage Page Removing the Coin-Cell Battery Installing the Power SupplyRemoving the Heatsink Assembly Installing the Coin-Cell BatteryRemoving the Processor Installing the Heatsink AssemblyRemoving the Intrusion Switch Installing the ProcessorInstalling the Intrusion Switch System Board Components Removing the System Board Page Installing the System Board Boot Sequence System SetupNavigation Keys System Setup Options COM1 Video Computrace Service from Absolute Software KEK Performance Post Behavior When Lookup Method is set to Static IP Updating the Bios System and Setup Password Clearing Forgotten PasswordClearing Cmos Assigning a System Password and Setup Password Disabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerBeep Code Error MessagesPage DIMM1 Page Page Technical Specifications Communications Power Page Contacting Dell