Dell D08S owner manual Installing the Hard Drive, Removing the Speaker

Page 18

Installing the Hard Drive

1.Tighten the screws to secure the mini hard drive (if available) to the hard-drive bracket.

2.Flex the hard-drive bracket and then insert the hard drive into the bracket.

3.Slide the hard-drive bracket into the drive cage.

4.Install the:

a)drive cage

b)optical drive

c)cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the Speaker

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)cover

b)optical drive

c)drive cage

3.Perform the following steps as shown in the illustration:

a)Disconnect the speaker cable from the system board [1]

b)Release it from the securing tab inside the chassis. [2].

4.Perform the following steps as shown in the illustration:

a)Press the speaker-securing tab [1].

b)Slide the speaker towards the right of the computer to release it [2].

18

Image 18
Contents Regulatory Model D08S Regulatory Type D08S001 Page Contents Diagnostics Working on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your ComputerPage Page Removing and Installing Components Recommended ToolsSystem Overview Removing the Cover Installing the Cover Installing the Front Bezel Removing the Front BezelRemoving The Expansion Card Page Installing The Expansion Card Removing the Optical DriveInstalling the Optical Drive Removing the Drive CageInstalling the Drive Cage Removing the Hard Drive Installing the Hard Drive Removing the SpeakerInstalling the Speaker Memory Module GuidelinesInstalling the Memory Removing the MemoryRemoving the System Fan Installing the System Fan Removing the Power SwitchInstalling the Power Switch Removing the I/O Panel Installing the I/O Panel Removing the Power SupplyPage Page Installing the Power Supply Removing the Coin-Cell BatteryInstalling the Coin-Cell Battery Removing the Heatsink AssemblyInstalling the Heatsink Assembly Removing the ProcessorInstalling the Processor Removing the Intrusion SwitchInstalling the Intrusion Switch System Board Components Removing the System Board Page Installing the System Board System Setup Boot SequenceNavigation Keys System Setup Options COM1 Video Computrace Service from Absolute Software KEK Performance Post Behavior When Lookup Method is set to Static IP Updating the Bios Clearing Forgotten Password System and Setup PasswordClearing Cmos Assigning a System Password and Setup Password Disabling a System Password Page Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Power LED DiagnosticsError Messages Beep CodePage DIMM1 Page Page Technical Specifications Communications Power Page Contacting Dell