Dell D08S owner manual Installing the I/O Panel, Removing the Power Supply

Installing the I/O Panel

1.Insert the I/O panel into the slot on the chassis front.

2.Slide the I/O panel to secure it to the chassis.

3.Tighten the screw to secure the I/O panel to the chassis.

4.Connect the I/O panel, audio cable, and fan shelter clip to the system board.

5.Install the:

a)drive cage

b)optical drive

c)front bezel

d)cover

6.Follow the procedures in After Working Inside Your Computer.

Removing the Power Supply

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove:

a)cover

b)front bezel

c)optical drive

d)drive cage

3.Perform the following steps as shown in the illustration:

a)Press the 8–pin and 4–pin power cable [1].

b)Disconnect the 8-pin and 4–pin power cables from the system board [2].

c)Unroute the cable from the system board.

24