Dell D08S owner manual Installing the System Fan, Removing the Power Switch

Page 21

Installing the System Fan

1.Place the system-fan in the chassis.

2.Pass the grommets through the chassis and slide outward along the groove to secure it in place.

3.Connect the system-fan cable to the system board.

4.Install:

a)front bezel

b)drive cage

c)optical drive

d)cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the Power Switch

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

b)front bezel

c)optical drive

d)drive cage

3.Perform the following steps as shown in the illustration:

a)Disconnect the power-switch cable from the system board.

b)Unroute the cable from the system board.

21

Image 21

Contents Regulatory Model D08S Regulatory Type D08S001 Page Contents Diagnostics Before Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerPage Page Removing and Installing Components Recommended ToolsSystem Overview Removing the Cover Installing the Cover Installing the Front Bezel Removing the Front BezelRemoving The Expansion Card Page Removing the Optical Drive Installing The Expansion CardRemoving the Drive Cage Installing the Optical DriveInstalling the Drive Cage Removing the Hard Drive Removing the Speaker Installing the Hard DriveMemory Module Guidelines Installing the SpeakerInstalling the Memory Removing the MemoryRemoving the System Fan Removing the Power Switch Installing the System FanInstalling the Power Switch Removing the I/O Panel Removing the Power Supply Installing the I/O PanelPage Page Removing the Coin-Cell Battery Installing the Power SupplyRemoving the Heatsink Assembly Installing the Coin-Cell BatteryRemoving the Processor Installing the Heatsink AssemblyInstalling the Processor Removing the Intrusion SwitchInstalling the Intrusion Switch System Board Components Removing the System Board Page Installing the System Board System Setup Boot SequenceNavigation Keys System Setup Options COM1 Video Computrace Service from Absolute Software KEK Performance Post Behavior When Lookup Method is set to Static IP Updating the Bios Clearing Forgotten Password System and Setup PasswordClearing Cmos Assigning a System Password and Setup Password Disabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerBeep Code Error MessagesPage DIMM1 Page Page Technical Specifications Communications Power Page Contacting Dell