Error Message | Description |
Bad command or | Ensure that you have spelled the command correctly, put spaces in the proper |
file name | place, and used the correct pathname. |
Bad error- | The floppy or hard drive controller detected an uncorrectable read error. |
correction code |
|
(ECC) on disk read |
|
Controller has | The hard drive or the associated controller is defective. |
failed |
|
Data error | The floppy or hard drive cannot read the data. For the Windows operating system, |
| run the chkdsk utility to check the file structure of the floppy or hard drive. For |
| any other operating system, run the appropriate corresponding utility. |
Decreasing | One or more memory modules may be faulty or improperly seated. |
available memory | memory modules and, if necessary, replace them. |
Diskette drive 0 | A cable may be loose or the computer configuration information may not match |
seek failure | the hardware configuration. |
Diskette read | The floppy disk may be defective or a cable may be loose. If the drive access light |
failure | turns on, try a different disk. |
Diskette | The floppy drive controller may be faulty. |
subsystem reset |
|
failed |
|
Gate A20 failure | One or more memory modules may be faulty or improperly seated. Reinstall the |
| memory modules and, if necessary, replace them. |
General failure | The operating system is unable to carry out the command. This message is usually |
| followed by specific |
| appropriate action to resolve the problem. |
The hard drive failed initialization. | |
configuration |
|
error |
|
The hard drive failed initialization. | |
controller failure |
|
The hard drive failed initialization. | |
failure |
|
The hard drive failed initialization. | |
read failure |
|
Invalid | The computer configuration information does not match the hardware |
configuration | configuration. |
information- |
|
please run SETUP |
|
program |
|
Invalid Memory | DIMM1 slot does not recognize a memory module. The module should be re- |
configuration, | seated or installed. |
53