Message | Causes | Corrective Actions |
|
|
|
No boot sector on | Incorrect configuration | Check the hard drive |
hard drive. | settings in System Setup | configuration settings in the |
| program, or no operating | System Setup program. |
| system on hard drive. | See "Using the System Setup |
|
| Program and |
|
| UEFI Boot Manager" on |
|
| page 57. If necessary, install |
|
| the operating system on your |
|
| hard drive. See your |
|
| operating system |
|
| documentation. |
|
|
|
No timer tick | Faulty system board. | See "Getting Help" on |
interrupt. |
| page 187. |
PCIe Training | Faulty or improperly | Reseat the PCIe card in the |
Error: Expected | installed PCIe card in the | specified slot number. |
Link Width is x, | specified slot. | See "Troubleshooting |
Actual Link Width |
| Expansion Cards" on |
is y. |
| page 172. If the problem |
|
| persists, see "Getting Help" |
|
| on page 187. |
|
|
|
Plug & Play | Error encountered in | Install the NVRAM_CLR |
Configuration | initializing PCIe device; | jumper in the clear position |
Error | faulty system board. | (pins 1 and 3) and reboot the |
|
| system. See Figure |
|
| jumper location. If the |
|
| problem persists, |
|
| see "Troubleshooting |
|
| Expansion Cards" on |
|
| page 172. |
|
|
|
Quad rank DIMM | Invalid memory | Ensure that the memory |
detected after | configuration. | modules are installed in a |
single rank or |
| valid configuration. |
dual rank DIMM in |
| See "General Memory |
socket. |
| Module |
|
| Installation Guidelines" on |
|
| page 105. |
About Your System
47