Message | Causes | Corrective Actions |
Read fault Requested sector not found
The operating system cannot read from the hard drive, optical drive, or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.
Replace the optical medium, USB medium, or USB device. Ensure that the USB cables, SAS/SATA backplane cables, or optical drive cables are properly connected.
See "Troubleshooting a USB Device" on page 158, "Troubleshooting an Optical Drive" on page 168, or "Troubleshooting a Hard Drive" on page 169 for the appropriate drive(s) installed in your system.
SATA Port x | There is no device connected | Information only. |
device not | to the specified SATA port. |
|
found |
|
|
Sector not found | Faulty hard drive, USB | Replace the USB medium or |
Seek error | device, or USB medium. | device. Ensure that the USB |
| or SAS backplane cables are | |
Seek operation |
| |
| properly connected. See | |
failed |
| "Troubleshooting a USB |
|
| Device" on page 158 or |
|
| "Troubleshooting a Hard |
|
| Drive" on page 169 for the |
|
| appropriate drive(s) installed |
|
| in your system. |
|
|
|
Shutdown failure | General system error. | See "Getting Help" on |
|
| page 187. |
Sparing mode The memory configuration
disabled. For does not match the setting
sparing mode, in BIOS. The BIOS setting
matched sets has been disabled. of three must
be populated across slots.
Reconfigure the memory modules for Memory Sparing mode. See "System Memory" on page 104.
48
About Your System