cards.
This device is unconfigurable because of a resource conflict with card card_name. The conflicting resource is resource_name. To fix, reconfigure the conflicting card.
The selected card is unconfigurable because one of its resources is already being used by another device.
the Cancel button if the ICU does not display a message naming the conflicting card.
3.Repeat step 2 until the ICU displays a message box naming the conflicting card and the resource(s) in conflict. See the following table entry for an explanation of this message box.
Perform the following procedure:
1.Make a note of the card name and the type of conflicting resource.
2.Follow the procedure in "Modifying a Card" and change the value for resource_name used by card_name.
The ICU has successfully configured all Plug and Play cards in your system. For the new configuration to take effect, save the configuration, then reboot your system.
The loaded card is not a category card. Press OK to proceed.
No more DMA values can be added.
No more interrupt values can be added.
No more memory values can be added.
No more I/O port values can be added.
The ICU detects
a resource conflict between this card and conflicting_card.The conflicting resource was: resource.
The ICU has successfully configured all of the Plug and Play expansion cards that were not configured by the Configuration Manager.
The category you have chosen is not the correct category under which to add this card.
No more values are available for the resource you are trying to add or modify.
You added or modified a card that now requires a resource value
already in use by conflicting_card.
To accept these settings, save the configuration information into NVRAM by selecting Exit from the File menu and then selecting Yes to save. You must reboot your system for these settings to take effect.
Select OK. The ICU automatically opens the correct category's dialog box. Continue the procedure for adding the card as described in "Adding an Unlisted Card".
The maximum number of values for each resource is as follows:
4 DMA channels
7 IRQ lines
9 memory address blocks
20 I/O ports
To free values for the resource you are trying to add or modify, delete some of the values listed in the resource box for the card. If your card requires all of the values listed, contact your card manufacturer to resolve the issue.
Try each of the following options until the problem is resolved:
Modify the card you are adding so that it uses a different value for resource. See "Modifying a Card" for instructions.
Modify conflicting_card so that it uses a different value for resource. See "Modifying a Card" for instructions.
If conflicting_card is not the system board or riser board, remove it from the computer. See "Removing a Card" for instructions.
Remove all expansion cards from the ICU, and then add them back one at a time, beginning with the new card and resolving resource conflicts as they arise. See "Removing a Card" and "Adding