Entering the System Setup Program, System Setup Screen

Using the System Setup Program: Dell™ Precision™ WorkStation 610 Mini Tower Systems

Overview	Entering the System	System Setup Screen	Using the System Setup	System Setup
	Setup Program		Program	Options
Using the System	Using the Setup Password	Disabling a Forgotten	Responding to Error
Password Feature	Feature	Password	Messages

Overview

Each time you turn on your computer system or press the reset button, the system compares the hardware installed in the system to the hardware listed in the system configuration information stored in nonvolatile random-access memory (NVRAM) on the system board. If the system detects a discrepancy, it generates error messages that identify the incorrect configuration settings. The system then prompts you to enter the System Setup program to correct the setting.

You can use the System Setup program as follows:

To change the system configuration information after you add, change, or remove any hardware in your system To set or change user-selectable options - for example, the time or date on your system

To enable or disable all integrated devices in your system

You can view the current settings at any time. When you change a setting, in many cases, you must reboot the system before the change takes effect.

After you set up your system, run the System Setup program to familiarize yourself with your system configuration information and optional settings. For future reference, Dell recommends that you print the System Setup screen (by pressing the <Print Screen> key) if you have a local printer installed, or write down the information if you do not have a printer.

Before you use the System Setup program, you need to know the kind of diskette drive(s) and hard-disk drive(s) installed in your computer. If you are unsure of any of this information, see the Manufacturing Test Report that was shipped with your system and is located in the Dell Accessories folder.

Entering the System Setup Program

Enter the System Setup program as follows:

1.Turn on your system.

If your system is already on, shut it down and then turn it on again.

2.When the Press <F2> to Enter Setup window appears in the upper-right corner of the screen, press <F2>.

If you wait too long and your operating system begins to load into memory, let the system complete the load operation; then shut down the system and try again.

NOTE: To ensure an orderly system shutdown, consult the documentation that accompanied your operating system.

You can also enter the System Setup program by responding to certain error messages. See "Responding to Error Messages".