CD D R I V E C O N T R O L L E R F A I L U R E — The CD drive does not respond to commands from the computer.
D A T A E R R O R — The hard drive cannot read the data.
D E C R E A S I N G A V A I L A B L E M E M O R Y — One or more memory modules may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. See your Service Manual at support.dell.com for more information.
D I S K C: F A I L E D I N I T I A L I Z A T I O N — The hard drive failed initialization. Run the hard drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 42).
D R I V E N O T R E A D Y — The operation requires a hard drive in the bay before it can continue. Install a hard drive in the hard drive bay. See your Service Manual at support.dell.com for more information.
E R R O R R E A D I N G PCMCIA C A R D — The computer cannot identify the ExpressCard. Reinsert the card or try another card. See your Service Manual at support.dell.com for more information.
E X T E N D E D M E M O R Y S I Z E H A S C H A N G E D — The amount of memory recorded in
nonvolatile memory (NVRAM) does not match the memory installed in the computer. Restart the computer. If the error appears again, contact Dell (see "Contacting Dell" on page 65).
T H E F I L E B E I N G C O P I E D I S T O O L A R G E F O R T H E D E S T I N A T I O N D R I V E — The file
that you are trying to copy is too large to fit on the disk, or the disk is full. Try copying the file to a different disk or use a larger capacity disk.
AF I L E N A M E C A N N O T C O N T A I N A N Y O F T H E F O L L O W I N G C H A R A C T E R S : \ / : * ? “ <
> — Do not use these characters in filenames.
G A T E A20 F A I L U R E — A memory module may be loose. Reinstall the memory modules and, if necessary, replace them. See your Service Manual at support.dell.com for more information.
G E N E R A L F A I L U R E — The operating system is unable to carry out the command. The message is usually followed by specific
H A R D - D I S K D R I V E C O N F I G U R A T I O N E R R O R — The computer cannot identify the
drive type. Shut down the computer, remove the hard drive (see your Service Manual at support.dell.com), and boot the computer from a CD. Then, shut down the computer, reinstall the hard drive, and restart the computer. Run the Hard Disk Drive tests in the Dell Diagnostics (see "Dell Diagnostics" on page 42).
36