Dell P776N, P01E manual Upgrading/Replacing Hard Drives, Removing the Hard Drives

Upgrading/Replacing Hard Drives

Your notebook is equipped with two sets of hard drive sockets.

•If only one hard drive is being installed, place the primary hard drive in the socket indicated by the “HDD0” designation.

•If two hard drives are being installed, place the primary hard drive in the socket indicated by the “HDD0” designation and the secondary hard drive in the socket indicated by the “HDD1” designation.

Below are the three major scenarios:

•One Windows® bootable hard drive: The hard drive should be placed in the primary hard drive socket (HDD0).

•One Windows® bootable hard drive and another Windows® non-bootable hard drive: The bootable hard drive should be placed in the primary hard drive socket (HDD0).

•Both hard drives are Windows® bootable: Choose the hard drive you want the computer to boot up from and have this drive installed in the primary hard drive socket (HDD0).

CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS

Removing the Hard Drives

Use the procedure below to remove your system’s the hard disk drives.

1.Follow the instructions in “Before You Begin” on page 33.

2.Loosen the two captive screws and remove the compartment door.

1

2

3

1	compartment door	3 front of the notebook
2	captive screws (2)

037/037