Chapter 2
Installation
Introduction to EthIR LAN Components
Clarinet EthIR LAN includes EthIR Switch and EthIR Beam. Model number description follows. For description of “Pass Through” mode refer to page
ES208 - 8 port Pass Through ES216 - 16 port Pass Through
ES608 - 4 port EthIR LAN with 4 PDA sockets ES101 - single port infrared only
ES301 - single infrared port with additional Ethernet port and OBEX function ES3011b - single infrared port with 802.11b uplink and OBEX function ES1000 - single infrared port with flash memory for content and OBEX function
After EthIR LAN is installed you must configure it for your network. See Chapter 3, “Configuring EthIR LAN” for additional information on this topic.
Installation Requirements
Wiring
The EthIR Switch (ES208 / 216 / 608) requires standard UTP Category 3 or 5 wire with
Power (ES 208 / 216 / 608)
The EthIR Switch automatically detects and supports both the US and European 110/220 power supply and configures itself accordingly.
Power (ES101 / 301 / 3011b / 1000)
The ES101 will have a power supply specific to the installed region.
Resetting
To reset the system, unplug the EthIR Switch power cord and wait at least 4 seconds before plugging the unit in again.