Clarinet Systems EthIR LAN manual NVM Editor, General Info Tab

Page 28

The NVM Editor

General Info Tab

The General Info tab of NVM Editor contains configuration information required by the Switch. Select the appropriate Switches first using the Tool then click Edit Configuration. The NVM Editor dialog is displayed, as illustrated below:

Settings include the Switch’s IP address, Subnet Mask, and optional Gateway IP. The DNS IP 1 and 2 fields as well as the Proxy field have been included to support Internet connectivity for IR/PPP devices required to connect to the EthIR Switch. After all required tab fields are modified, click Update to update the IP information of the Switch. Clicking Done will reboot the switch if IP information is updated. If using the DHCP option, all IP entries (except the Proxy IP) will be obtained automatically.

Note: Do not change MAC Address..

3-8

Image 28

Contents EthIR LAN User Guide Page Clarinet Systems, Inc Copyright Table of Contents Updating The Firmware Switch Security Chapter ClarinetIR Appendix F Page User Profile Introducing EthIR LANHow this Guide Is Organized Appendices ConventionsContacting Clarinet Systems Page Installation Requirements Introduction to EthIR LAN ComponentsInstallation Order of InstallationEthIR Switch ES208 / 216 EthIR Beam Supported PlatformsInstall EthIR Switch ES208 EthIR Switch ES101/301/3011b/1000Install EthIR Switch ES101 / 301 / 3011b IR/PPPInfrared Mode ES208 / 216 only Pass Through Mode ES208 / 216 onlyUnderstanding the EthIR Switch Panel LEDs ES208 / 216 only EthIR Beam EthIR Soft Family of ProductsInfrared Support for Windows ClarinetIRCSI Configuration Tool Configure EthIR SwitchIntroduction CSI Configuration Tool Installation CSI Configuration Tool FunctionsConnectivity Choices for Using the CSI Configuration Tool CSI Configuration Tool Window DescriptionConfigure via Infrared Setting The IP Address Of The Switch For The First Time Configure via IP addressClick the Configure via Infrared Searching For EthIR Switches Above picture illustrates the discovery of three Switches NVM Editor General Info TabSnmp Variables Tab IP Pool Tab except ESB3011bRF Card Info ESB3011B only Model ES101 / 301 Models ES208 / 216WEP ESB3011b only Switch Security Updating The FirmwareChapter ClarinetIR Page Installing Infrared Support for Windows Appendix aPage Page Binding TCP/IP Protocol for Notebook IPX/SPXPage Page Appendix B Page Appendix C Disabling Puma Technology’s IR Communication SoftwarePage Appendix D Browsing the Network Neighborhood Windows 95/98Page Appendix E Upgrading from 115Kbps to 4Mbps SpeedsPage Page Page Configuration Options Before You Begin Needed Changes to Your SystemUsing IrLAN with Windows 95 Notebooks Click Options Page Using Direct Cable Connection with Windows 98 Notebooks Install Direct Cable ConnectionPage Configure Infrared Monitor for Direct Cable Connection Configure Direct Cable Connection for the First Time Page Connecting to and Disconnecting from the Network Page Using Direct Cable Connection with Windows 2000 Notebooks Page Configuring Windows CE Handheld PCs Adding Direct Connection to Remote NetworkingPage Click OK to finish the configuration of the new connection Specifying an Http Proxy Server Using IrLAN with Apple MacOS Powerbooks Configuring Palm Organizers