8.When the Add Infrared Device Wizard prompts you to select the virtual COM and LPT ports, accept the default values as illustrated below and click the Next button.
9.After the wizard copies the IR communications driver files to the hard disk, the wizard displays two New Hardware Found messages:
-
-
Infrared Serial Connection (COM) port Infrared printer (LPT) port.
Note: If the New Hardware Found messages were not displayed, reboot your notebook and repeat steps 1 through step 9)
10.When the Add Infrared Device Wizard prompts you, click Finish to complete the IR device installation.
11.Start Up. Infrared Monitor must be launched each time you wish to use infrared communication. The setup program allows you to choose whether to launch the
Infrared Monitor each time automatically upon startup by clicking Yes to the following question. If you do not want it to launch automatically each time click No, however, you will need to manually launch Infrared Monitor each time you wish to connect via infrared.
12.Point the EthIR Beam at your notebook’s infrared port. With the infrared drivers now loaded, Windows 95 recognizes the Clarinet EthIR Switch as the new hardware device. Windows 95 starts the