Clarinet Systems EthIR LAN manual Click the Configure via Infrared

Page 25

The following steps describe how to set the IP address of the EthIR Switch for the first time from a notebook running Windows with an enabled Infrared capability:

Models ES208 / 216 / 608
DHCP off. Generic IPs entered	DHCP option turned on

1.Launch the Infrared applet in the Control Panel to insure that “enable infrared” is enabled and the “plug and play” feature is disabled.

2.Install the CSI Configuration Tool software on the notebook.

3.Point and EthIR Beam to the notebook’s infrared port.

4.Launch the CSI Configuration Tool.

5. Click the Configure via Infrared.

3-5

Image 25

Contents EthIR LAN User Guide Page Clarinet Systems, Inc Copyright Table of Contents Updating The Firmware Switch Security Chapter ClarinetIR Appendix F Page User Profile Introducing EthIR LANHow this Guide Is Organized Conventions AppendicesContacting Clarinet Systems Page Introduction to EthIR LAN Components Installation RequirementsOrder of Installation InstallationEthIR Switch ES208 / 216 EthIR Beam Supported PlatformsEthIR Switch ES101/301/3011b/1000 Install EthIR Switch ES208IR/PPP Install EthIR Switch ES101 / 301 / 3011bPass Through Mode ES208 / 216 only Infrared Mode ES208 / 216 onlyUnderstanding the EthIR Switch Panel LEDs ES208 / 216 only EthIR Soft Family of Products EthIR BeamClarinetIR Infrared Support for WindowsCSI Configuration Tool Configure EthIR SwitchIntroduction CSI Configuration Tool Functions CSI Configuration Tool InstallationConnectivity Choices for Using the CSI Configuration Tool CSI Configuration Tool Window DescriptionConfigure via Infrared Configure via IP address Setting The IP Address Of The Switch For The First TimeClick the Configure via Infrared Searching For EthIR Switches Above picture illustrates the discovery of three Switches General Info Tab NVM EditorIP Pool Tab except ESB3011b Snmp Variables TabModel ES101 / 301 Models ES208 / 216 RF Card Info ESB3011B onlyWEP ESB3011b only Updating The Firmware Switch SecurityChapter ClarinetIR Page Appendix a Installing Infrared Support for WindowsPage Page IPX/SPX Binding TCP/IP Protocol for NotebookPage Page Appendix B Page Disabling Puma Technology’s IR Communication Software Appendix CPage Browsing the Network Neighborhood Windows 95/98 Appendix DPage Upgrading from 115Kbps to 4Mbps Speeds Appendix EPage Page Page Before You Begin Needed Changes to Your System Configuration OptionsUsing IrLAN with Windows 95 Notebooks Click Options Page Install Direct Cable Connection Using Direct Cable Connection with Windows 98 NotebooksPage Configure Infrared Monitor for Direct Cable Connection Configure Direct Cable Connection for the First Time Page Connecting to and Disconnecting from the Network Page Using Direct Cable Connection with Windows 2000 Notebooks Page Adding Direct Connection to Remote Networking Configuring Windows CE Handheld PCsPage Click OK to finish the configuration of the new connection Specifying an Http Proxy Server Using IrLAN with Apple MacOS Powerbooks Configuring Palm Organizers