Clarinet Systems EthIR LAN manual

Page 65

4.Click OK to return to Make New Direct Connection dialog and click on TCP/IP Settings…. Currently, Clarinet supports the specification in the General TCP/IP dialog box. Again, no change is required although it

would be helpful to understand what is entailed in these dialogs.

Note: Support of some of the items is negotiated as the connection session begins. The EthIR Switch from which the EthIR Beam is extended automatically assigns the IP address of your HPC. SLIP protocol is not supported. Software compression and IP header compression are negotiated. The EthIR Switch assigns the HPC IP address. Compression is not supported.

5. Click on the Name Servers tab.

6.The domain name server are configured in the Switch and do not have to be configured into the CE device. The Switch passes all information to the CE device.

F-15

Image 65

Contents EthIR LAN User Guide Page Clarinet Systems, Inc Copyright Table of Contents Updating The Firmware Switch Security Chapter ClarinetIR Appendix F Page How this Guide Is Organized Introducing EthIR LANUser Profile Conventions AppendicesContacting Clarinet Systems Page Introduction to EthIR LAN Components Installation RequirementsOrder of Installation InstallationEthIR Switch ES208 / 216 EthIR Beam Supported PlatformsEthIR Switch ES101/301/3011b/1000 Install EthIR Switch ES208IR/PPP Install EthIR Switch ES101 / 301 / 3011bPass Through Mode ES208 / 216 only Infrared Mode ES208 / 216 onlyUnderstanding the EthIR Switch Panel LEDs ES208 / 216 only EthIR Soft Family of Products EthIR BeamClarinetIR Infrared Support for WindowsIntroduction Configure EthIR SwitchCSI Configuration Tool CSI Configuration Tool Functions CSI Configuration Tool InstallationConfigure via Infrared CSI Configuration Tool Window DescriptionConnectivity Choices for Using the CSI Configuration Tool Configure via IP address Setting The IP Address Of The Switch For The First TimeClick the Configure via Infrared Searching For EthIR Switches Above picture illustrates the discovery of three Switches General Info Tab NVM EditorIP Pool Tab except ESB3011b Snmp Variables TabModel ES101 / 301 Models ES208 / 216 RF Card Info ESB3011B onlyWEP ESB3011b only Updating The Firmware Switch SecurityChapter ClarinetIR Page Appendix a Installing Infrared Support for WindowsPage Page IPX/SPX Binding TCP/IP Protocol for NotebookPage Page Appendix B Page Disabling Puma Technology’s IR Communication Software Appendix CPage Browsing the Network Neighborhood Windows 95/98 Appendix DPage Upgrading from 115Kbps to 4Mbps Speeds Appendix EPage Page Page Before You Begin Needed Changes to Your System Configuration OptionsUsing IrLAN with Windows 95 Notebooks Click Options Page Install Direct Cable Connection Using Direct Cable Connection with Windows 98 NotebooksPage Configure Infrared Monitor for Direct Cable Connection Configure Direct Cable Connection for the First Time Page Connecting to and Disconnecting from the Network Page Using Direct Cable Connection with Windows 2000 Notebooks Page Adding Direct Connection to Remote Networking Configuring Windows CE Handheld PCsPage Click OK to finish the configuration of the new connection Specifying an Http Proxy Server Using IrLAN with Apple MacOS Powerbooks Configuring Palm Organizers