thermal or thermal transfer printing, tear mode, etc.
To enter the printer setup mode, press and hold down the Pause key then press the Feed key and release both keys. The functions of the control keys are described below.
Changes to the printer configuration are stored in “nonvolatile memory”. This guarantees that the printer configuration is maintained even after the power is turned off.
n Pause key: | Selects the mode. |
n Feed key: | Selects the mode item. |
n Stop key: | Saves the selection contents and returns the printer to the |
| normal operating mode. |
The functions indicated by an ♦ character work on the CLP 1001, 2001, 6001, 6002 and 6401 printers. Those with a ● character work on the CLP 7201e and 7202e printers
E N G L I S H
LCD Indication
♦● | Transfer | DirectTM |
|
♦ | Peel OFF | Peel ON |
|
♦ | Cut OFF | Cut ON |
|
♦ | Tear OFF | Tear ON |
|
● | AfterPrt | PeelWait | AutoCut |
|
| TearBar | NoAction |
♦● | Edge | Reflect | ContinuP |
● | HeadHeat | Heat 01 | Heat 30 |
● | PrintSpd | PSpeed 2 | PSpeed 7 |
● | Feed Spd | FSpeed 2 | FSpeed 7 |
● | Back Spd | BSpeed 2 | BSpeed 7 |
● | Vert Adj | V+2.00in | |
● | HorizAdj | H+2.00in | |
● | StopPos | S+2.00in | |
● | SetLckOF | SetLckON |
|
Function Description
Direct thermal or thermal transfer printing
Enable or disable peeler function Enable or disable cutter function Enable or disable
“AfterPrint” functions. Set the operation of the printer after the label has been printed.
Select media gap detection method either “edge” (label gap), reflective or continuous media
Set the printhead temperature
Set the print speed in inches/second Set the feed speed in inches/second Set the back feed speed in inch/sec Vertical label position adjustment.
Horizontal label position adjustment. Stop position adjustment
Settings Lock Off/On. When “on”, causes the printer to ignore commands changing the above values set on the control panel.