Self-Test Mode And Hex Dump | Citizen Systems CLP 6002, CLP 7202e

E N G L I S H

2.4 Self-Test Mode And Hex Dump

The printer enters the self-test mode when the Feed key is pressed and held down while turning the printer on.

If the Feed key is held down for more than four seconds, the printer assumes continuous media is installed.

The printer performs a two-page self-test print then enters the Hex Dump or Data Dump mode (prints out the communication data by ASCII code).

The printer returns to the normal operating mode only when the power is turned off.

2.5 System Maintenance Mode

The printer enters the system maintenance mode when the Pause, Feed and Stop keys are pressed and held down simultaneously while turning the printer on.

The printer enters the communication parameter setting, system setups and paper gap and black line sensor sensitivity adjusting mode.

The mode is selected with the Pause key and the mode item is selected with the Feed key. Changing of the contents is executed as soon as they are displayed on the screen. Pressing the Stop key returns the printer to the normal operating mode.

LCD Indication

9600bps 19200bps 38400bps

8 bits	7 bits
NativeOF	NativeON
fVirtual	fReal
Cmnd STD	Cmnd AS4	Cmnd RST
AjSensOF	AjSensOn
PE x.xxV	BL x.xxV

Function Description

Select baud rate between 38,400 bps down to 300 bps.

Select 8 or 7 data bits

Select Native Off or Native On mode.

Select distance of media sensor relative to the printhead position.

Select between standard command set, AS400 mode or raster mode.

Select between fixed media and adjustable sensor when installed.

See through or black line sensor checking mode. See Section 2.6