Citizen Systems CLP 1001, CPL 2001, CLP 6001, CPL 6002, CPL 6401, CPL 7201e, CPL 7202e, CLP 7202e

2.6 Adjusting the sensors for different media

The voltage setting mode, part of the system setting mode, is used to correctly adjust the see-through or black line sensors for the particular type of media being used in the printer. The ideal voltage is between 3.0v and 3.3v for both the PE (paper end or gap) and BL (black line) modes.

Adjustment procedure for label paper (with label gap):

1Remove a label from the backing paper (liner) and set the liner ONLY under the media sensor (see section 3.4).

2 Adjust the paper gap value on the control panel to a value	PE 3.05v
between 3.0 volts and 3.3 volts. Adjustment is made using

the upper adjuster on the control panel. See section 2.1

Adjustment procedure for media with a black line on the reverse side:

1Set the unmarked part of the media – the area without the black line - under the media sensor (see section 3.4).

2 Adjust the black line value on the control panel to a value	BL 3.05v
between 3.0 volts and 3.3 volts. Adjustment is made using

the middle adjuster on the control panel. See section 2.1

2.6 Factory Default Settings

To return the print to Factory Default settings, press and hold down the Pause, Feed and Stop keys simultaneously for more than four seconds whilst turning on the power.

S Maint	The display will first show “S Maint”
S/I Init	You must keep the buttons held down until the LCD displays the
	message “S/I Init”

E N G L I S H