E N G L I S H
Chapter 3 – Paper & Ribbon
3.1 Media Installation
CAUTION Take care not to trap lose clothing in the mechanism of the printer when it is closed!
The printer is designed for easy loading of paper and ribbon. However, here is a detailed guide for
1 Push down the open lever | ① | ⑩ | |
to release the print head and | |||
| |||
lift it out of the way |
| ① | |
2Push down the sensor arm lever ③ to move the sensor arm ② out of the way (not present on the CLP 1001)
3Slide the black plastic media guide ⑤ over the media support bar ④ and insert the support bar through the roll of media being installed.
4Rest the media support bar in to the paper holder ⑥ and slide the roll guide ⑤ to the width of the roll paper. The paper roll should be pushed
against the side nearest the top cover hinges move easily.
②
Roll
⑤
④
⑥
③
⑥*, but should still be free to
5Place the media on the main printer chassis, with the left side of the media against the fixed paper guide ⑧. Slide the small moving paper guide ⑦ to
maintain the correct media width slightly in
contact the right edge of the media so that⑤ the paper does not skew.
6Push down the sensor arm ② until the lever hook is locked (not CLP 1001).
7Roughly align the leading edge of the paper with the
8 | Close the top mechanism by pressing down | ⑥ |
| the ribbon bearing flat ⑩ to close the print |
|
| head. The mechanism will lock closed. |
|
9 | Close the cover. |
|
10 | Turn on the power to the printer. The LCD |
|
| screen on the control panel will display "On | ⑧ |
| line." Press the Feed key. The paper will | |
|
|
advance to the next label and stop there.
④
⑥
③
⑦
⑨
Notch for alignment