E N G L I S H
3.3 Ribbon Installation (CLP 7201e, 7202e)
CAUTION Be careful of the edges of the plates so injury or property damage is possible.
After opening the cover, install the ribbon as follows:
1Push down the head open lever to move the print head out of the way.
2Insert the ribbon shaft in the roll ribbon so that it is in its deepest position.
3Set it in the ribbon holder as shown in the figure.
4Pull the ribbon from under the transfer mechanism to the ribbon winding side.
5Insert the ribbon shaft in the paper core so that it is in its deepest position. Then set it in the ribbon winder as shown in the figure.
6Stick the top end of the ribbon to the paper core with adhesive tape. Turn the ribbon winder in the direction ribbon winding to remove slackness and wrinkles from the ribbon.
NOTE: the CLP 7201e and CLP 7202e destination (used) ribbon winds in the opposite direction to the CLP 1001, 2001 and 6000 series.
7Close the mechanism and press down the green plastic to lock the mechanism, then close the cover.
8Turn on the power to the printer. The LCD screen on the control panel will display "On line." Press the Feed key. The paper will advance to the next label and stop there.
For specialist ribbons, adjustments to the