Hypercom ICE 5000 manual Step-by-Step

Page 23

l

This section contains inportant information that will help properly install ICE 5000 and 5500 terminals.

s

Use the following procedures to power up the ICE 5000 or 5500 terminals.

Step-by-Step

To power up the ICE terminal:

1.Connect the +24 Vdc power cable from the AC Adaptor to the three-pin terminal socket labeled POWER on the back panel of the ICE 5000 or 5500 terminals.

2.Plug the AC Adaptor into a 110-Volt grounded power receptacle. Be sure the connector is firmly seated. When the power is connected successfully, the terminal beeps twice and then performs a self-test and diagnostic routine.

Power socket

Figure 2-1. ICE 5000 power socket

Image 23

Contents FS Gkdgodiggg Page Trademarks CTR21 Industry Canada IC Notice Page L s Z srv w l K l Page Terminal dimensions Page 940184-003, rev. B Hypercom Corporation Xiii Step-by-Step Main menu, click Network Definitions’ Page ICE 5000 and 5500 terminals Chapter Slq s Wzl W This display is configurable Terminals Length Width Height Page Step-by-Step Chapter Do not insert the telephone line into the Pin pad port Description Terminal response Boot Page To configure the ICE terminal INIT. Telephone no To load a program into the ICE terminal To initialize an ICE terminals Leg Mggg ICE 5000 printer paper installation Leg Mmgg ICE 5500 printer paper installation Disabled. Enable? Page Page Chapter Wireless POS Terminal Interface Extending basic coverage Wireless POS Terminal Interface Large area coverage Premises wiring diagram Figures 4-5 through 4-7 are installation examples Extended basic example Large area example Numerics SAM Additional comments Page Page Document Number 940184-003, rev B