Hypercom ICE 5000 manual Disabled. Enable?

Page 37

					Setup Procedures

	a.	At the main terminal display, touch u			.
	b.	Touch the		. The Terminal Main menu prompt appears.
	c.	Touch		. The Setup menu appears.
	d.	Touch		. The Printer prompt appears.
	e.	Touch zz . The Printer Toggle menu prompt appears. The menu displays Printer is
		disabled. Enable?.
	f.	Touch		. The terminal changes the printer settings to Enabled and returs to the main menu.
		Repeat steps 4 through 9.
10.	Touch		. The system returns to the main terminal menu.
11.	Close the printer paper cover.

940184-003, rev. B

Hypercom Corporation

3-9

Image 37

Contents FS Gkdgodiggg Page Trademarks CTR21 Industry Canada IC Notice Page L s Z srv w l K l Page Terminal dimensions Page 940184-003, rev. B Hypercom Corporation Xiii Step-by-Step Main menu, click Network Definitions’ Page ICE 5000 and 5500 terminals Chapter Slq s Wzl W This display is configurable Terminals Length Width Height Page Step-by-Step Chapter Do not insert the telephone line into the Pin pad port Description Terminal response Boot Page To configure the ICE terminal INIT. Telephone no To load a program into the ICE terminal To initialize an ICE terminals Leg Mggg ICE 5000 printer paper installation Leg Mmgg ICE 5500 printer paper installation Disabled. Enable? Page Page Chapter Wireless POS Terminal Interface Extending basic coverage Wireless POS Terminal Interface Large area coverage Premises wiring diagram Figures 4-5 through 4-7 are installation examples Extended basic example Large area example Numerics SAM Additional comments Page Page Document Number 940184-003, rev B