Hypercom ICE 5000 manual Extending basic coverage

Chapter 4

4.Insert the male connector on the 12-foot cable from the terminal transceiver into the female connector on the single-unit adapter cable.

5.If the 12-foot cable is not long enough, it may be extended up to 100 feet by using any six- conductor, one-to-one standard telephone extender cable available at various electronic appliance retail outlets. The cable may be extended up to 1000 feet by substituting a terminal transceiver interface for the single unit adapter cable.

g

To avoid damaging the terminal transceiver unit, do not insert the cable connectors from the single unit adapter or the terminal transceiver into any receptacle designated for use with the premises telephone system .

g

If the basic system does not cover enough space or major gaps exist in the coverage, you can extend the area covered. The example in Figure 4-2 shows how to extend coverage or fill in gaps by adding a terminal transceiver interface and an additional terminal transceiver.

Figure 4-2. Extending basic coverage

l d

Use this procedure for installing the extended basic coverage wireless hardware.

Step-by-Step

To install the extended basic coverate area:

1.Ensure the host terminal is properly configured and connected for use as a standard POS terminal.

See the manual provided with the host POS terminal.

2.If this is a system upgrade from the basic system, discard the single unit adapter cable. Insert one end of the PIN pad cable, Hypercom P/N 810022-001, into the PIN pad port of the host POS terminal. Insert the other end of the PIN pad cable into the connector marked To Terminal on the terminal transceiver interface.

4-4 ICE 5000 and 5500 Hardware and Installation Operators Manual 940184-003, rev. B