Wireless POS Terminal Interface

Figure 4-1 shows the basic ICE configuration. The terminal transceiver should be less than 100 feet from the peripheral terminal device. This short range reduces the possibility of interference with other communication systems using the same radio spectrum. Causing such interference is a violation of FCC regulations.

Figure 4-1. Basic configuration

d l

Use the following procedure to install the basic system wireless hardware.

Step-by-Step

To install the basic system:

1.Ensure the host terminal is properly configured and connected for use as a standard POS terminal.

See the manual provided with the host POS terminal.

2.Insert the male end of the single unit Hypercom adapter cable, Hypercom P/N 810170-001, into the PIN pad port of the host terminal.

3.Mount the terminal transceiver, Hypercom P/N 020123-002, to a vertical surface. Place it as high as possible in an area that has the best visibility from the area where the peripheral terminal devices are used. You may mount the transceiver by using the metal hook or the rubber suction cups provided. An alternate method is to remove the metal hook and the rubber suction cups, replacing them with double-sided tape. The terminal transceiver must not be mounted on or next to metal objects.

940184-003, rev. B

Hypercom Corporation

4-3