Hypercom ICE 5000 manual Leg Mmgg

Page 35

Setup Procedures

leg MMGG

To properly install the printer paper into the termial, read the following steps carefully.

Step-by-Step

To load the printer paper in the ICE 5500:

1. Open the printer paper cover on the back of the ICE 5500 printer.

Figure 3-4. ICE 5500 printer paper door open

2.Place the paper roll into the printer paper holder, make sure the printer paper unrolls from under the roll, not over the top, and has a straight-line path into the printer paper-feed mechanism.

3.Place the end of the paper in the paper guide. The printer then automatically feeds the paper. If the printer does not automatically feed the paper, proceed with step 4. Otherwise, proceed to step 10.

940184-003, rev. B

Hypercom Corporation

3-7

Image 35

Contents FS Gkdgodiggg Page Trademarks CTR21 Industry Canada IC Notice Page L s Z srv w l K l Page Terminal dimensions Page 940184-003, rev. B Hypercom Corporation Xiii Step-by-Step Main menu, click Network Definitions’ Page ICE 5000 and 5500 terminals Chapter Slq s Wzl W This display is configurable Terminals Length Width Height Page Step-by-Step Chapter Do not insert the telephone line into the Pin pad port Description Terminal response Boot Page To configure the ICE terminal INIT. Telephone no To load a program into the ICE terminal To initialize an ICE terminals Leg Mggg ICE 5000 printer paper installation Leg Mmgg ICE 5500 printer paper installation Disabled. Enable? Page Page Chapter Wireless POS Terminal Interface Extending basic coverage Wireless POS Terminal Interface Large area coverage Premises wiring diagram Figures 4-5 through 4-7 are installation examples Extended basic example Large area example Numerics SAM Additional comments Page Page Document Number 940184-003, rev B