Hypercom manual ICE 5000 printer paper installation

Page 34

Chapter 3

3.Place the end of the paper in the paper guide. The printer then automatically feeds the paper. If the printer does not automatically feed the paper, proceed with step 4. Otherwise, proceed to step 9.

Figure 3-2. ICE 5000 printer paper installation

		Figure 3-3. ICE 5000 Printer paper installation complete
4.	Touch	on the terminal display.
5.	Touch z . The Main prompt appears.
6.	Touch	. The Other prompt appears.
7.	Touch	. The Printer prompt appears.
8.	Touch	. Continue to touch	until the paper feeds through the printer tear bar.
9.	Close the paper door.

3-6

ICE 5000 and 5500 Hardware and Installation Operators Manual

940184-003, rev. B

Image 34

Contents FS Gkdgodiggg Page Trademarks CTR21 Industry Canada IC Notice Page L s Z srv w l K l Page Terminal dimensions Page 940184-003, rev. B Hypercom Corporation Xiii Step-by-Step Main menu, click Network Definitions’ Page ICE 5000 and 5500 terminals Chapter Slq s Wzl W This display is configurable Terminals Length Width Height Page Step-by-Step Chapter Do not insert the telephone line into the Pin pad port Description Terminal response Boot Page To configure the ICE terminal INIT. Telephone no To load a program into the ICE terminal To initialize an ICE terminals Leg Mggg ICE 5000 printer paper installation Leg Mmgg ICE 5500 printer paper installation Disabled. Enable? Page Page Chapter Wireless POS Terminal Interface Extending basic coverage Wireless POS Terminal Interface Large area coverage Premises wiring diagram Figures 4-5 through 4-7 are installation examples Extended basic example Large area example Numerics SAM Additional comments Page Page Document Number 940184-003, rev B