Hypercom ICE 5000 manual ICE 5500 printer paper installation

Page 36

Chapter 3

Figure 3-5. ICE 5500 printer paper installation

		Figure 3-6. ICE 5500 Printer paper installation complete
4.	At the main terminal display, touch u		.
5.	Touch the	. The Terminal Main menu prompt appears.
6.	Touch	. The Setup menu appears.
7.	Touch	. The Printer prompt appears.
8.	Touch	. The Paper Feed menu appears.
9.	Touch	until the paper feeds through the printer tear bar.

wzl W If the printer fails to advance the paper, you may need to check the printer ON/OFF settings. Complete the following steps to verify the settings.

3-8

ICE 5000 and 5500 Hardware and Installation Operators Manual

940184-003, rev. B

Image 36

Contents FS Gkdgodiggg Page Trademarks CTR21 Industry Canada IC Notice Page L s Z srv w l K l Page Terminal dimensions Page 940184-003, rev. B Hypercom Corporation Xiii Step-by-Step Main menu, click Network Definitions’ Page ICE 5000 and 5500 terminals Chapter Slq s Wzl W This display is configurable Terminals Length Width Height Page Step-by-Step Chapter Do not insert the telephone line into the Pin pad port Description Terminal response Boot Page To configure the ICE terminal INIT. Telephone no To load a program into the ICE terminal To initialize an ICE terminals Leg Mggg ICE 5000 printer paper installation Leg Mmgg ICE 5500 printer paper installation Disabled. Enable? Page Page Chapter Wireless POS Terminal Interface Extending basic coverage Wireless POS Terminal Interface Large area coverage Premises wiring diagram Figures 4-5 through 4-7 are installation examples Extended basic example Large area example Numerics SAM Additional comments Page Page Document Number 940184-003, rev B