Metrologic Instruments IS1000 manual Table of Contents

TABLE OF CONTENTS

1.	INTRODUCTION			1
	1.1. Default Configuration (factory setting)			3
2.	COMMUNICATION MODES			5
	2.1.	RS232	....................................................................................................................	6
		2.1.1.	Baud Rate	6
		2.1.2.	Data Bits	7
		2.1.3.	Parity	7
		2.1.4.	Stop Bits	7
		2.1.5.	End of Message Character	8
		2.1.6.	Time-Out Between Characters	9
		2.1.7.	ACK/NAK Protocol	10
		2.1.8.	XON/XOFF Protocol	10
		2.1.9.	RTS/CTS Protocol	10
		2.1.10. PC-Term Mode		11
	2.2.	Keyboard-Wedge		12
		2.2.1. End of Message Character		14
		2.2.2. Upper / Lower Case Options		14
		2.2.3. Types of Numeric Characters		15
		2.2.4.	Time-Out Between Characters	15
		2.2.5.	"WYSE" Time-Out	16
	2.3. P.O.S. (Point Of Sale) Systems			17
	2.4.	Wand Emulation		18
		2.4.1.	Transmission Speed	18
		2.4.2.	Bar/Space Polarity	19
		2.4.3.	Idle State	19
	2.5.	Laser Emulation		20
3.	SYMBOLOGIES			21
	3.1.	Symbology Selection		22
	3.2.	Code 39		24
		3.2.1.	Standard/Full ASCII	24
		3.2.2.	Full ASCII Extended	24
		3.2.3.	Multiread	25
		3.2.4. Modulo 43 Check Character		25
		3.2.5. Pharmacode or Pharma 32/39		26
		3.2.6.	CIP Code 39	26
		3.2.7.	Start/Stop	27
		3.2.8.	Modulo 43 Algorithm	27
	3.3.	Interleaved 2/5		28
		3.3.1. Fixed Length(s) Authorized and Set Upon First Reading(s)		28
		3.3.2. Fixed Length(s) Authorized and Set Using the Numeric Pad		29
		3.3.3.	Variable Lengths Authorized	30
	3.4.	UPC/EAN		31

IS1000 – Configuration Guide iii