Metrologic Instruments IS1000 manual Timer T1

Page 59

4.5. Setting the Timers

	Operating Mode		Default Value

		Timer T1	Timer T2	Timer T3
		Timer T1	Timer T2	Timer T3


	Simple Acknowledgment	200 ms

	Host System Acknowledgment	200 ms	3 s	2 s
	On File / Not On File	200 ms	3 s	2 s
	Bell	200 ms	3 s
	Bell	200 ms	3 s

4.5.1.Timer T1

Default value = 200 ms

ACCESS CODE TIMER T1

Enter the desired value

using the Numeric Pad page 81

(Step of 10 ms)

10 ≤ value ≤ 254

VALIDATION

START OF CONFIGURATION	END OF CONFIGURATION

IS1000 – Configuration Guide	51

Image 59

Contents IS1000 Series Page Mlpn Metrologic Instruments Italia S.r.L Table of Contents UCC/EAN Editing Mode Appendixes Intentionally left blank Introduction Symbologies Default Configuration Default Configuration factory settingIntentionally left blank Communication Modes Baud Rate RS232Stop Bits Data Bits ParityEnd of Message Character Time-Out Between Characters RTS/CTS Protocol ACK/NAK ProtocolXON/XOFF Protocol PC-Term Mode Keyboard-Wedge PC Keyboard Type Upper / Lower Case Options Types of Numeric Characters Wyse Time-Out Ocia P.O.S. Point Of Sale SystemsTransmission Speed Wand EmulationIdle State Bar/Space PolarityLaser Emulation Symbologies Symbology Selection Standard 2/5 MSI Plessey Telepen Code Matrix 2/5 Iata Full Ascii Extended CodeStandard/Full Ascii Modulo 43 Check Character MultireadCIP Code Pharmacode or Pharma 32/39Modulo 43 Algorithm Start/StopInterleaved 2/5 Fixed Lengths Authorized and Set Upon First ReadingsFixed Lengths Authorized and Set Using the Numeric Pad Variable Lengths Authorized Transformations UPC/EANTypes of UPC/EAN Authorized Add-On Options Flag Option Leading Prefixes for P.O.S. SystemsIsbn Conversion Check Digit OptionsProduct Code Concatenation Monarch/CodabarFNC2 Function Check CharacterStart FNC1 ID Data Stop UCC/EANStart/Stop Types Standard 2/5Number of Lengths Authorized Single Check Digit Modulo MSIVariable or Fix Lengths Double Check Digit ModuloTelepen PlesseyFixed or Variable Lengths Matrix 2/5Types of Start/Stop Check DigitSetting the Authorized Lengths 16 W7 Iata15. BC Identifier with Three Characters Leading IdentifiersIdentifier with One Character Decoding Selectivity Intentionally left blank Simple Acknowledgment Operating ModesOn File / Not On File Host System AcknowledgmentSetting the Not On File Character Setting the On File CharacterBell Timer T1 Timer T3 Timer T2Editing Mode IS1000 Configuration Guide Appendixes Number of Re-transmissions Radio Base Adjustment of the Beep Sound 6.2.1. Laser ReaderClear Buffer Preamble / PostamblePreamble Character Postamble CharacterFirst Character Conversion of CharactersIS1000 Configuration Guide Second Character Rolling Buffer Mode Transmission of the Full Ascii Character Set Displaying the Firmware Level Code 39 Full Ascii Extended Table Reserved Multiread character Table IS1000 Configuration Guide IS1000 Configuration Guide Ascii Code 39 Full Ascii TableDEL NUL SOH STX ETX EOT ENQ ACK BEL DLE DC1 DC2 DC3 DC4 NAK SYN ETB Can SUB ESC IS1000 Configuration Guide IS1000 Configuration Guide IS1000 Configuration Guide IS1000 Configuration Guide IS1000 Configuration Guide DEL Intentionally left blank Numeric Pad Samples of Bar Codes UPC E UPC a Intentionally left blank