Powermatic 2700 manual Templates, Securing the Template

Page 28

Templates

The template must be thick enough to provide a solid bearing edge against a collar. When constructing a template similar to the one shown in Figure 49, keep in mind that it serves only as a guide for the cutter.

If the workpiece requires all-around shaping, the template can be constructed from several sections pieced together as shown in Figure 50.

Securing the Template

There are various methods used to secure the template to the workpiece. The experienced operator will choose the most appropriate according to the shape, size, and type construction of the template. For example, if the workpiece is large enough to extend beyond the front of the table and still leave room for the desired cut, it can be securely held to the template with "C" clamps as shown in Figure 51.

In many situations the workpiece is positioned against the template using dowels as anchor points and handles (wood blocks) to assist the operator in guiding the work-piece through the cut as shown in Figure 52.

Figure 49

Figure 50

Figure 51

Figure 52

28

Image 28
Contents Model 2700 Shaper Warranty and Service More InformationTable of Contents Page Page Figure a Introduction Specifications Spindle Capacity Under NutShipping Contents InstallingUnpacking Assembly Electrical ConnectionsMounting the Fence General InformationVoltage Conversion 3 Phase Shaper only Extension CordsFence Assembly Movement AdjustmentsHandwheel Adjustments Coplanar Alignment Coplanar AdjustmentVerifying that fences are coplanar Ram Dial Calibration Loosen the outfeed fence lock knob BFeatherboard Hold-downs Spindle Gib AdjustmentLoosen lock handles C and lock knobs D Spindle Assembly Installation Spindle Assembly RemovalInstalling the Spindle Assembly Locking the ArborShaper Cutter Installation Router Collet Optional InstallationInstalling the Shaper Cutter Locking the SpindleChanging Cutter Speed Belt ReplacementDrive Belt Tension Precision Miter Gauge Loosen lock handle aSafety Key Operating ControlsStart/Stop Digital ReadoutSafety Devices OperationsOverview Grain Direction ConsiderationsUsing the Fence Depth of Cut DimensionStraight Edge Shaping Edge Shaping End ShapingShaping All Sides On-Edge ShapingStraight Line Bevel Shaping Contour Edge Shaping With Collar BearingShaping With Collars Position of CollarsStarting Pin Arcs and Circles Enclosed Edge ShapingTemplates Securing the TemplateStacked Cutters Special CutsSash and Door Shaping Butt Joints Glue Butt JointTongued Joint Drop Leaf JointTenoning Troubleshooting See also Unsatisfactory CutsOrdering Replacement Parts Optional AccessoriesParts Table Parts List Index No Description Size QtyTable Assembly Drawing Fence Parts List Index No. Part No Description Size QtyFence Assembly Drawing Frame and Motor Parts List Frame and Motor Assembly Drawing Elevator Parts List Elevator Assembly Drawing Caster Assembly Parts List Caster Assembly Drawing Spindle Assembly Parts List Spindle Assembly Drawing Spindle 30mm Spindle 4 SpindleCabinet and Base Parts List PM2700-454 Motor Cable 3HP, 1Ph Cabinet and Base Wiring 3HP/5HP Diagrams 1PhaseMagnetic Switch 5HP, 230V, 3Phase5HP, 460V, 3Phase New Sanford Road LaVergne, TN Phone