Powermatic 2700 manual Optional Accessories, Ordering Replacement Parts

Trouble

Raised areas on shaped edge.

Work pulled from hand.

Depth of cut not uniform.

Work burns.

Cut height not uniform.

Cuts not smooth.

Spindle does not raise freely.

	Possible Cause		Remedy
1.	Variation of pressure holding work	1.	Hold work firmly against table and
	against cutter.		fence. Use hold-downs and push
			sticks.
1.	Feeding in wrong direction.	1.	Always feed work against the
			rotation of the cutterhead.
1.	Fence misalignment.	1.	Align outfeed fence.
2.	Side pressure not uniform.	2.	Use hold-downs; keep constant
			pressure against fence and use
			push sticks.
1.	Cutting too deep on one pass.	1.	On hardwoods take light cuts; attain
			full depth with several passes.
2.	Forcing work.	2.	Feed work slowly and steadily.
1.	Variation in pressure holding work	1.	Keep pressure uniform throughout
	to table.		pass. Use hold-downs. Make pass
			slowly and steadily. Keep work
			under cutter whenever possible.
1.	Wrong R.P.M.	1.	Use faster speed.
2.	Feed too fast.	2.	Slow feed speed.
3.	Working against the grain.	3.	Work with the grain whenever
			possible.
4.	Cutting too deep on one pass.	4.	Take several passes on very deep
			cuts.
1.	Shaper dust and dirt in raising	1.	Brush or blow out loose dust and
	mechanism.		dirt.

Optional Accessories

1791204	1/2" Spindle
1791205	1" Spindle
1791206	30mm Spindle
1791207	1/4" Collet
1791208	1/2" Collet

Parts

Ordering Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

33