Unpacking
Remove box and wood crating completely from around shaper. Check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Shaper is assembled and running properly.
Compare the contents of your container with the parts lists on this page to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.
Shipping Contents
Referring to Figure 1:
Main Shaper Container
1Fence Assembly (A)
1Cabinet and Base (B)
Hardware and included tools consist of the following items:
2 Lock Handle (C)
2M13 Flat Washer (D)
1Miter Assembly (E)
1Draw Bar (F)
1
13/4" Spindle (H)
2Spindle Nut (I)
3Insert Rings – 2.55”, 4.16”, 5.75” (J)
4M10 Socket Head Cap Screw (K)
4M10 Lock Washer (L)
1Starting Pin (M)
18 mm Hex Wrench (N)
1Crosspoint/Flathead Screwdriver (O)
1Wrench (P)
Installing
1.Unbolt the shaper from the skid.
2.Carefully slide the shaper from the pallet onto the floor.
Make sure that the casters do not get damaged when removing from the skid.
The Shaper should be placed in an area with a sturdy level floor, good ventilation and sufficient lighting. Leave enough space around the machine for mounting extension wings and rail assemblies, and loading and
Main Shaper Container
Hardware
Figure 1
8