Lynx L-210 manual PPPoA Connection Setup

Page 11

service provider or your ISP will supply these; in this case the DSL service provider is using 0,100. Also select the quality of service (QOS); leave the default value if you are unsure or the ISP did not provide this information.

Following is a description of the different options:

a.Username: The username for the PPPoA access; this is provided by your DSL service provider or your ISP.

b.Password: The password for the PPPoA access; this is provided by your DSL service provider or your ISP.

c.On-Demand: Enables on-demand mode. The connection will disconnect if no activity is detected after the specified idle timeout value.

d.Idle Timeout: Specifies that PPPoA connection should disconnect if the link has no activity detected for n seconds. This field is used in conjunction with the On-Demand feature. To ensure that the link is always active, enter a 0 in this field.

e.Keep Alive: When on-demand option is not enable, this value specifies the time to wait without being connected to your provider before terminating the connection. To ensure that the link is always active, enter a 0 in this field.

f.Set Route: Specify this connection as the default-route.

g.MRU: Maximum Receive Unit the DSL connection can receive. It is a negotiated value that asks the provider to send packets of no more than n bytes. The maximum specified value is 1500 although some DSL/ISP providers require a larger value. The minimum MRU value is 128.

Figure 5 (PPPoA Connection Setup)

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support LED description Your gateway at a glancePorts and buttons Installing your Lynx L-210 Quick Start Setting up your Lynx L-210Log into your Lynx L-210 Quick Start Setup for advance userNew Connection Configuring the WANWide Area Network connection Local Area Network connectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modify an Existing Connection Configuring the LANModem setup Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressUPnP Firewall/NAT ServicesAdvanced for advance user only Port Forwarding Advanced Security Access ControlMAC Address Filters Access ControlLAN clients MAC Multicast Dynamic Routing Static RoutingTools System CommandsPing Test Update FirmwareUser Management Connection Status StatusModem Test Network StatisticsSystem Log Dhcp ClientsModem Status Product InformationDSL Link LED continues to blink but does not go solid Appendix a TroubleshootingLynx L-210 is not functional Can’t connect to the Lynx L-210DSL Link LED is always off Lynx L-210 terms What is a firewall?
Top Page Image Contents