Lynx L-210 manual Dhcp Connection Setup

Page 13

Figure 6 (PPPOE Connection Setup)

To complete the connection you must now click the apply button. The apply button will temporarily save this connection. To make the change permanent you need to click on Save Setting (at the side of the page). At the system commands page, click on Save All.

4.4.1.4 DHCP Connection Setup

Dynamic Host Configuration Protocol (DHCP) allows the Lynx L-210 to automatically obtain the IP address from the server. This option is commonly used in situations where IP is dynamically assigned and is not known prior to assignment.

To configure the Lynx L-210 for a DHCP connection, click on Setup and then click on New Connection. The default DHCP connection setup is displayed. At the Type field select DHCP and the DHCP connection setup page is displayed; figure 7 illustrates a typical DHCP configuration. Give your DHCP connection a unique name; the name must not have spaces and cannot begin with numbers. In this case the unique name is called DHCP1. Select the encapsulation type (LLC or VC); if you are not sure just use the default mode. Select the VPI and VCI settings; your DSL service provider or your ISP will supply these; in this case the DSL service provider is using 0,100. Also select the quality of service (QOS); leave the default value if you are unsure or the ISP did not provide this information.

If your DSL line is connected and your DSL/IPS provider is supporting DHCP, you can click the renew button and the gateway will retrieve an IP address, Subnet mask, and Gateway address. At anytime, you can renew the DHCP address by clicking on the renew button; in most cases you will never have to use this button.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support Ports and buttons Your gateway at a glanceLED description Installing your Lynx L-210 Log into your Lynx L-210 Setting up your Lynx L-210Quick Start Quick Start Setup for advance userWide Area Network connection Configuring the WANLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modem setup Configuring the LANModify an Existing Connection Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressAdvanced for advance user only Firewall/NAT ServicesUPnP Port Forwarding Advanced Security Access ControlLAN clients Access ControlMAC Address Filters MAC Multicast Dynamic Routing Static RoutingTools System CommandsUser Management Update FirmwarePing Test Modem Test StatusNetwork Statistics Connection StatusModem Status Dhcp ClientsProduct Information System LogLynx L-210 is not functional Appendix a TroubleshootingCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off Lynx L-210 terms What is a firewall?
Top Page Image Contents