Lynx L-210 manual DSL Link LED is always off

Page 31

5.4The DSL Link LED is always off

1.Make sure you have DSL service. You should get some kind of information from your ISP that states that DSL service is installed. You can usually tell if the service is installed by listening to the phone line; you will hear some high-pitched noise. If you do not hear high- pitched noise, contact your ISP.

2.Verify that the phone line is connected directly to the wall and to the line input on the Lynx L- 210. If the phone line is connected to the phone side of the Lynx L-210 or you have a splitter installed on the phone line, the DSL light will not come on.

31

Image 31

Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support Ports and buttons Your gateway at a glanceLED description Installing your Lynx L-210 Log into your Lynx L-210 Setting up your Lynx L-210Quick Start Quick Start Setup for advance userNew Connection Configuring the WANWide Area Network connection Local Area Network connectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modem setup Configuring the LANModify an Existing Connection Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressAdvanced for advance user only Firewall/NAT ServicesUPnP Port Forwarding Advanced Security Access ControlLAN clients Access ControlMAC Address Filters MAC Multicast Dynamic Routing Static RoutingTools System CommandsUser Management Update FirmwarePing Test Connection Status StatusModem Test Network StatisticsSystem Log Dhcp ClientsModem Status Product InformationDSL Link LED continues to blink but does not go solid Appendix a TroubleshootingLynx L-210 is not functional Can’t connect to the Lynx L-210DSL Link LED is always off Lynx L-210 terms What is a firewall?