Lynx L-210 manual Configuring the WAN, Wide Area Network connection, Local Area Network connection

Page 9

4.3.1 Wide Area Network connection

On the other side of the Lynx L-210 is where your Wide Area Network (WAN) connection; also referred to as a broadband connection. This WAN connection is different for every WAN supplier. Most of the configuration you will perform will be in this area. Local Area Network Connection(s)

4.3.2 Local Area Network connection

On one side of your Lynx L-210, you have your own Local Area network (LAN) connections. This is where you plug in your local computers to the Lynx L-210. The Lynx L-210 is normally configured to automatically provide all the PC's on your network with Internet addresses.

4.4Configuring the WAN

Before the gateway will pass any data between the LAN interface(s) and the WAN interface, the WAN side of the modem must be configured. Depending upon your DSL service provider or your ISP, you will need some (or all) of the information outlined below before you can properly configure the WAN:

•Your DSL line VPI and VCI

•Your DSL encapsulation type and multiplexing

•Your DSL training mode (default is MMODE)

•For PPPoA or PPPoE users, you also need these values from your ISP: o Your username and password

•For RFC 1483 users, you may need these values from your ISP: o Your DSL fixed Internet IP address

o Your Subnet Mask

o Your Default Gateway

o Your primary DNS IP address

Since multiple users can use the Lynx L-210, the Lynx L-210 can simultaneously support multiple connection types; hence, the user must set up different profiles for each connection. The Lynx L-

210 supports the following protocols:

•DHCP

•RFC2364 / PPPoA

•RFC2516 / PPPoE

•Static

•Bridged

•RFC1577 / CLIP

4.4.1 New Connection

A new connection is basically a virtual connection. Your Lynx L-210 can support up to 8 different (unique) virtual connections. If you have multiple different virtual connections, you may need to utilize the static and dynamic routing capabilities of the modem to pass data correctly.

4.4.1.1 Bridged gateway profile and Connection

A pure bridged connection does not assign and IP address to the WAN interface. NAT and firewall rules are not enabled. This connection method makes the Lynx L-210 act as a hub, and just passes packets across the WAN interface to the LAN interface.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support Your gateway at a glance Ports and buttonsLED description Installing your Lynx L-210 Setting up your Lynx L-210 Log into your Lynx L-210Quick Start Quick Start Setup for advance userWide Area Network connection Configuring the WANLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Configuring the LAN Modem setupModify an Existing Connection Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressFirewall/NAT Services Advanced for advance user onlyUPnP Port Forwarding Advanced Security Access ControlAccess Control LAN clientsMAC Address Filters MAC Multicast Dynamic Routing Static RoutingTools System CommandsUpdate Firmware User ManagementPing Test Modem Test StatusNetwork Statistics Connection StatusModem Status Dhcp ClientsProduct Information System LogLynx L-210 is not functional Appendix a TroubleshootingCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off Lynx L-210 terms What is a firewall?
Top Page Image Contents