Lynx L-210 manual Dhcp Clients, Modem Status, Product Information, System Log

Page 29

4.8.3 DHCP Clients

Select to view the list of DHCP clients.

4.8.4 Modem Status

Select to view the Status and Statistics of your broadband (DSL) connection.

4.8.5 Product Information

You can display the Lynx L-210’s driver and run-time information by going under Status title and click on Product Information. Figure 21 illustrates the typical product information, which is provided.

Figure 21 (Product Information)

4.8.6 System Log

You can display the Lynx L-210’s log by going under the Status title, click System log. From here you can view all logged information. Depending upon the severity level, this logged info will generate log reports to a remote host (if remote logging is enabled).

29

Image 29

Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support LED description Your gateway at a glancePorts and buttons Installing your Lynx L-210 Quick Start Setting up your Lynx L-210Log into your Lynx L-210 Quick Start Setup for advance userWide Area Network connection Configuring the WANLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modify an Existing Connection Configuring the LANModem setup Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressUPnP Firewall/NAT ServicesAdvanced for advance user only Port Forwarding Advanced Security Access ControlMAC Address Filters Access ControlLAN clients MAC Multicast Dynamic Routing Static Routing Tools System CommandsPing Test Update FirmwareUser Management Modem Test StatusNetwork Statistics Connection StatusModem Status Dhcp ClientsProduct Information System LogLynx L-210 is not functional Appendix a TroubleshootingCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off Lynx L-210 terms What is a firewall?