Lynx L-210 manual Modem Test, Network Statistics, Connection Status

Page 28

default DHCP configuration, you should be able to Ping the network address 192.168.1.1. If your ISP has provided their server address you can try to ping the address. If the pings for both the WAN and the LAN side complete, and you have the proper protocols configured, you should be able to surf the Internet.

By default when you select ping test, the Lynx L-210 will ping itself 3 times. As shown in Figure 20, the Lynx L-210 passed the Ping test; this basically means that the TCP/IP protocol is up and running. If this first Ping test does not pass, the TCP/IP protocol is not loaded for some reason; you should restart the Lynx L-210.

Figure 20 (Ping test)

4.7.5 Modem Test

The Modem Test is used to check whether your Lynx L-210 is properly connected to the WAN Network. This test may take a few seconds to complete. To perform the test, select your connection from the list and press the Test button. Before running this test, make sure you have a valid DSL link; if the DSL link is not connected, this test will always fail.

Also the DSLAM must support this feature; not all DSLAMs have F4 and F5 support.

4.8Status

The Status section allows you to view the Status/Statistics of different connections and interfaces

4.8.1 Network Statistics

Select to view the Statistics of different interfaces - Ethernet/USB/DSL.

4.8.2 Connection Status

Select to view the Status of different connections.

28

Image 28
Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Features IntroductionManagement Support Ports and buttons Your gateway at a glanceLED description Installing your Lynx L-210 Log into your Lynx L-210 Setting up your Lynx L-210Quick Start Setup for advance user Quick StartConfiguring the WAN Wide Area Network connectionLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modem setup Configuring the LANModify an Existing Connection Enable/Disable Dhcp Changing the Lynx L-210 IP address Static IP address assignmentAdvanced for advance user only Firewall/NAT ServicesUPnP Port Forwarding Access Control Advanced SecurityLAN clients Access ControlMAC Address Filters MAC Multicast Static Routing Dynamic RoutingSystem Commands ToolsUser Management Update FirmwarePing Test Status Modem TestNetwork Statistics Connection StatusDhcp Clients Modem StatusProduct Information System LogAppendix a Troubleshooting Lynx L-210 is not functionalCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off What is a firewall? Lynx L-210 terms