Lynx manual Installing your Lynx L-210

Page 6

3.Installing your Lynx L-210

1. Locate an optimum location for the Lynx L-210.

2.For connections to the Ethernet and DSL interfaces, please refer to the easy start guide.

3.Connect the AC Power Adapter. Depending upon the type of network, you may want to put the power supply on an uninterruptible supply. Only use the power adapter supplied with the Lynx L-210. A different adapter may damage the product.

Now that the hardware installation is complete, proceed to Chapter 4: Setting up your Lynx L-210

6

Image 6

Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Features IntroductionManagement Support Your gateway at a glance Ports and buttonsLED description Installing your Lynx L-210 Setting up your Lynx L-210 Log into your Lynx L-210Quick Start Setup for advance user Quick StartLocal Area Network connection Configuring the WANWide Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Configuring the LAN Modem setupModify an Existing Connection Enable/Disable Dhcp Changing the Lynx L-210 IP address Static IP address assignmentFirewall/NAT Services Advanced for advance user onlyUPnP Port Forwarding Access Control Advanced SecurityAccess Control LAN clientsMAC Address Filters MAC Multicast Static Routing Dynamic RoutingSystem Commands ToolsUpdate Firmware User ManagementPing Test Network Statistics StatusModem Test Connection StatusProduct Information Dhcp ClientsModem Status System LogCan’t connect to the Lynx L-210 Appendix a TroubleshootingLynx L-210 is not functional DSL Link LED continues to blink but does not go solidDSL Link LED is always off What is a firewall? Lynx L-210 terms