Lynx L-210 manual Management Support

Page 4

Management Support

•Web Based HTTP management GUI

•TFTP/FTP Support for Firmware Upgrade

•Web Based Firmware Upgrade (Local)

•Soft Factory Reset Button via Web GUI

•Diagnostic Test (DSL, OAM, Network, Ping Test)

•Telnet/CLI (Read Only)

•Syslog Support

Security Support

•NAT for basic Firewall support

•Packet Filtering Firewall Support

•Stateful Packet Inspection Support

•Protection against Denial of Service attacks

•Password Authentication to Modem

External Connectors

•1 x RJ-11 Telephone socket for ADSL line

•1 x RJ45 for 10/100Base-T Ethernet (MDI-X)

•1 x USB 1.1 Type B

•1 x DC Jack for Power Input

•1 x Factory Default Reset Button

4

Image 4

Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Features IntroductionManagement Support Ports and buttons Your gateway at a glanceLED description Installing your Lynx L-210 Log into your Lynx L-210 Setting up your Lynx L-210Quick Start Setup for advance user Quick StartConfiguring the WAN Wide Area Network connectionLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Modem setup Configuring the LANModify an Existing Connection Enable/Disable Dhcp Changing the Lynx L-210 IP address Static IP address assignmentAdvanced for advance user only Firewall/NAT ServicesUPnP Port Forwarding Access Control Advanced SecurityLAN clients Access ControlMAC Address Filters MAC Multicast Static Routing Dynamic RoutingSystem Commands ToolsUser Management Update FirmwarePing Test Status Modem TestNetwork Statistics Connection StatusDhcp Clients Modem StatusProduct Information System LogAppendix a Troubleshooting Lynx L-210 is not functionalCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off What is a firewall? Lynx L-210 terms