Lynx L-210 manual Advanced Security, Access Control

Page 21

Figure 13 (Port Forwarding: Netmeeting)

The apply button will temporarily save this connection. To make the change permanent you need to click on Save Settings (at the side of the page). At the system commands page, click on Save All.

4.6.3 Advanced Security

In the presence of the firewall, anonymous Internet traffic is blocked. Using the advanced security features, you can redirect this traffic to a dedicated computer on your local network (DMZ) or open the access from the Internet to the Lynx L-210's management ports (web, telnet). The Lynx L-210's firewall and NAT services (port forwarding, access control) can be disabled for all interfaces by un- checking the "Enable Firewall and NAT Service"

To enable any of the advanced security features, click Advanced and configure the option under Firewall. Figure 14 illustrates the typical advanced security in Access Control configuration.

Figure 14 (Access Control)

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Web Interface User’s Guide DSL Link LED continues to blink but does not go solid Introduction FeaturesManagement Support Your gateway at a glance Ports and buttonsLED description Installing your Lynx L-210 Setting up your Lynx L-210 Log into your Lynx L-210Quick Start Quick Start Setup for advance userWide Area Network connection Configuring the WANLocal Area Network connection New ConnectionPPPoA Connection Setup PPPoA Connection Setup PPPoE Connection Setup Dhcp Connection Setup Static Connection Setup Page Configuring the LAN Modem setupModify an Existing Connection Enable/Disable Dhcp Static IP address assignment Changing the Lynx L-210 IP addressFirewall/NAT Services Advanced for advance user onlyUPnP Port Forwarding Advanced Security Access ControlAccess Control LAN clientsMAC Address Filters MAC Multicast Dynamic Routing Static RoutingTools System CommandsUpdate Firmware User ManagementPing Test Modem Test StatusNetwork Statistics Connection StatusModem Status Dhcp ClientsProduct Information System LogLynx L-210 is not functional Appendix a TroubleshootingCan’t connect to the Lynx L-210 DSL Link LED continues to blink but does not go solidDSL Link LED is always off Lynx L-210 terms What is a firewall?
Top Page Image Contents