Magma P13RR-TEL user manual RechecktheInstallation, Applying PowerCorrectly, Starting Up

Page 14

M A G M A

RechecktheInstallation

Check your installation before powering up the MAGMA expansion chassis for the first time. Although the power supply has an over voltage protection device built into it, it may not "trip" in time to fully protect a device that has been improperly connected, or whose power cable has been damaged.

Applying PowerCorrectly

Starting Up:

You must apply power to the MAGMA expansion chassis BEFORE you power up your computer. This will allow the higher numbered PCI buses in the PCI bus hierarchy to be at a stable state when the host system issues its master power-on bus reset. In systems that perform automatic PCI bus configuration, this will allow the configuration code to recognize the PCI bus hierarchy and any attached

devices.

There is an On/Off switch on the front panel, as well as LED indicators to indicate power status. Verify that the green power indicators are ON.

Windows XP and Windows 2000 Start Up

As your Windows XP/2000 computer starts up, you will see a small message box pop- up in the lower-right corner of the screen to alert you that Windows has found new hardware.

You are now ready to go. No drivers are needed. Now go to Chapter 3 Verify Installation.

6Chapter 2 Hardware Installation

Image 14

Contents Slot PCI to PCI Expansion Copyright 2007 Mission Technology Group, Inc. DBA Magma Table of Contents Chapter Chassis Maintenance Preface AdvisoriesSafetyInstructions WhenWorkingInsideaComputerProtecting Against Electrostatic Discharge Electrostatic Discharge ESD WarningIv Preface Introduction General SpecificationsPre-InstallationInformation ToolsRequiredforInstallation PartsListHardware Installation Install PCI HostInterfaceCard Before you BeginAttachPCIExpansionandPowerCable Starting Up RechecktheInstallationApplying PowerCorrectly Shutting Down MAC Start UpVerify Installation Windows2000andXPMacOSX G M a Install 3rd Party PCI Cards Remove PCI Expansion Chassis CoverPCI Expansion InterfaceCard InstallPCICards inPCI Expansion Chassis System Should BeUp and Running FinishingTouches Rack Installations Remote Monitoring Getting StartedConfiguring Surveillance Pro Surveillance Pro 2 WebChassis Name IP AddressG M a Subnet Mask and Gateway Address Surveillance Pro 2 Email Notification Setup Smtp AddressFrom Email Address Administration Name and Password SetupRecipient’s Email Address Email Address #1 #4 Finalizing Surveillance Pro 2 Configuration Removing Faults From Surveillance ProChassis Maintenance Hot-SwappablePowerSupplyReplacing a Fan AdjustingtheDigital DisplayWindow Troubleshooting LocatetheProblemMy Computer Can’t Find the PCI Expansion System WindowsWhen Nothing Works My Computer Hangs During Power Up My PCI Card Doesn’t Work Support for 3rd Party PCI Cards Windows Error Codes Error Code Description/ActionOn the PCI to PCI Bridge Magma Technical Support Contacting Technical Support How to Get More HelpFrequentlyAskedQuestionsFAQ Magma Debug Utility PCIScope Software Utility G M a ReturningMerchandisetoMAGMA Magma Returns DEPT. RMA #Appendix a Bus Hierarchy BusHierarchyMultiple PCI Expansion System Configurations Appendix B Need More Slots?Fan-Out Verify your configuration Urati o nDaisy-Chaining ExpansionSystems Daisy-ChainingCombination Configurations PCI Card Conflicts Power-On Sequence forAdvanced ConfigurationsTroubleshooting AdvancedConfigurations G M a Finding the Problem Card Appendix C Compliance IndustryCanadaPage Manual P/N 09-09907-01-A1