Magma P13RR-TEL user manual Before you Begin, Install PCI HostInterfaceCard

M A G M A

Before you Begin

The 400W redundant power supply is auto-switching. These means that it will automatically switch to match whatever source power you are using. Since all products ship with a US Standard 115V power cord, you will need to use a power cord adapter for non-US Standard 115V power sources.

Install PCI HostInterfaceCard

Begin the installation of your PCI expansion host card by first powering down the host computer. Use the procedures for shutting down your operating system and shutting off power to your system provided in your owner’s manual or system documentation.

The PCI Host Interface Card includes a voltage switch in the top right corner of the board that may need to be adjusted for proper installation. It is an easy process to determine if the voltage switch needs to be adjusted for your configuration.

1.Insert the PCI Host Interface Card into a vacant PCI slot by gently pushing the card until it is firmly seated.

2.Secure the card in the PCI slot opening with a mounting screw.

3.Turn on power to the host computer.

4.If both LEDs shown below are lit, DO NOT adjust the dip switch, simply power down and continue to step two.

5.If only the +5V LED is lit, shut down your computer, then flip the switch to the ON position before continuing to the next step. When you power up the computer again, both LEDs should now be lit.

4Chapter 2 Hardware Installation