Magma P13RR-TEL user manual Surveillance Pro 2 Web, Configuring Surveillance Pro

M A G M A

Surveillance Pro 2 Web Page

To view the status web page created by Surveillance Pro 2, open any web browser and simply type the default Surveillance Pro 2 IP address of 192.168.1.100 into the address bar. In a few moments you will see a web page showing the status of the P13RR-TEL critical parameters. The screen will automatically refresh every 30 seconds.

Your computer must be on the same IP address network as the Surveillance Pro 2 if you are not connected through a router.

The black text on the page represents all the parameters that can be monitored for a particular P13RR-TEL chassis. To the right of the black text is the status on each monitored parameter. If the status text is green, the parameter is in an acceptable, or “pass,” state. If the status text is red, the parameter is in a “fail” state. If there is no status text below the parameter heading, it is a parameter that is not monitored in this chassis.

To view the status of another P13RR-TEL, simply enter the IP address of the next chassis’ Surveillance Pro 2.

Configuring Surveillance Pro 2

To configure a Surveillance Pro 2, open the status web page as previously described. At the bottom of the page, there is a link to go to the Administration page. When you click on it, a password dialog box will appear. Enter a user name and password. The factory default for

18Chapter 5 Remote Monitoring