Telenetics CDMA manual Chapter Installation, Installation Summary

Page 10

Chapter 2

Installation

This chapter describes how to install the OMEGA CDMA Modem.

Installation Summary

Installing the OMEGA CDMA Modem involves the following steps:

1.Unpack your OMEGA CDMA Modem. See page 11.

2.Obtain the additional items you need for installation. See page 11.

3.Obtain cellular telephone service. See page 11.

4.If you have the stand-alone OMEGA CDMA Modem, attach the mounting feet. See page 12.

5.Install the optional RS-232 module, if appropriate. See Appendix B.

6.Connect the OMEGA CDMA Modem to a power supply. See page 12.

7.Set the OMEGA CDMA Modem DIP switch. See page 12.

8.Use the pre-programmed Telephone/Mobile Identification numbers to have your RTU originate calls to its host via the RS-232 Data Terminal Ready (DTR) signal. See page 14.

9.Attach an RS-232 cable. See page 14.

10.Power-up the OMEGA CDMA Modem. See page 16.

11.Verify that the OMEGA CDMA Modem can answer incoming calls. See page 16.

12.View the OMEGA CDMA Modem’s current configuration. See page 16.

Page 10

Image 10

Contents Omega Cdma Modem User’s Guide Important Notice FCC ID N7NSB555 FCC Radiation Exposure StatementFCC Part 15 EMI Statement Contents Chapter Introduction ModelsOptions FeaturesIntroduction Hardware Features InstallationType II Omega Cdma Modem Type II Omega Cdma Modem with Marwell Socket Adapter Chapter Installation Installation SummaryUnpacking Your Hardware Obtaining Cellular Telephone ServiceAT Commands Items Supplied by the UserPower Supply Connections Installing the Optional 8-Port RS-232 ModuleAttaching Mounting Feet stand-alone Omega Cdma Modem Setting the Omega DIP Switch Omega Cdma Modem Switch Settings DescriptionAttaching a DTE Cable DTR Dial EnableAT Commands DTE Baud Rate Switch Baud Rate bps OFFDCD OUT RTS TXD CTS RXD TX+ OUT RX+Call Answer Testing Powering-up the ModemConfiguring the Omega Cdma Modem LEDs LEDs Indicating Modem Control Signals SW5 onDTE Signal LEDs Indicating Rssi SW5 OFFChapter Troubleshooting Problem SolutionAppendix a AT Commands Table A-1. Basic AT Commands Parameter Description CommandString default is 2 seconds Table A-3. Basic Action Commands Parameter DescriptionCLIENT? ResetCLIENT= DTRAT Command Parameter Description ~NAMVAL= ~NAMLCK~NAMVAL?0 Write Account Activation DataAT Command Line Syntax Table A-6. Telenetics-Proprietary CommandsResult Codes AT Commands Table A-7. Result Codes Number Word Description Using S-RegistersOnly until the next reset or power off Page Verifying Package Contents Appendix B Installing the 8-port RS-232 ModuleInstallation Installing the 8-port RS-232 Module Eight-Port Module PortsLimited Product Warranty Return Merchandise Authorization RMA Procedure