Telenetics CDMA manual Table A-1. Basic AT Commands, Parameter Description Command

		AT Commands
		Table A-1. Basic AT Commands
AT	Parameter	Description
Command
E	0	Do not echo typed AT commands.
	1	Echo typed AT commands back to the attached DTE (default).
I	0	Display transceiver product version information.
	1	Display modem product version information.
P		Use pulse dialing.
Q	0	Return result codes (required for modem transceiver programming and
		Telenetics-proprietary commands)
	1	Suppress result codes.
T		Use tone dialing. (default)
V	0	Display result codes as numbers.
	1	Display result codes as words.
X	1	Enable additional result code CONNECT<rate>, dial tone and busy
		detection are both disabled.
	2	Enable additional CONNECT<rate> and NO DIALTONE result codes,
		dial tone detection is enabled, busy detection is disabled.
	3	Enable CONNECT<rate> and BUSY result codes, dial tone detection is
		disabled, busy detection is enabled.
	4	Enable CONNECT<rate>, BUSY, and NO DIALTONE result codes, dial
		tone detection and busy detection are enabled.
Z	0	Drop active call and reset to default configuration.
&C	0	Carrier Detect always ON.
	1	Carrier Detect follows data carrier (default).
&D	0	Ignore Data Terminal Ready (DTR).
	1	Go to Command Mode after ON-to-OFF DTR transition.
	2	Hang up and go to Command Mode after ON-to-OFF DTR transition.
&F		Set to factory default configurations.
&V		Dump configuration parameters.
&W		Save active configuration as user profile.

Page 20