Telenetics CDMA manual DTR Dial Enable, Attaching a DTE Cable, Off

Page 14

AT Commands

Table 2-3. DTE Baud Rate

Switch 1

Switch 2

Baud Rate (bps)

 

 

 

OFF

OFF

1200

OFF

ON

2400

ON

OFF

9600 (default)

ON

ON

19,200*

 

 

 

* If you select 19,200 bps, set switch 6 ON to enable hardware flow control.

DTR Dial Enable

Using pre-programmed Telephone/Mobile Identification numbers, your RTU can originate calls to its host using the RS-232 Data Terminal Ready (DTR) signal. To enable this feature, set switch 7 to the ON position. Then use the AT*DTR command to assign the number that the OMEGA CDMA Modem is to dial (see Table A-4 on page 22). Then, when the RTU raises its DTR signal, the modem automatically dials the stored telephone number and attempts to establish a data connection. Once a remote connection is made, a drop in the DTR signal ends the connection.

Attaching a DTE Cable

Note: If the stand-alone OMEGA CDMA Modem is purchased from Telenetics, the RS-232 connection has already been made and this section can be skipped. However, if the Marwell socket adapter option is purchased from Telenetics or if the RS-485 interface is to be used, please read this section.

The OMEGA CDMA Modem provides two DTE connectors:

™One for an RS-232 connection.

™One for an RS-485 connection.

Both of these connectors are RJ-11 jacks. Only one of these connectors should be used at a time. Switch 8 on the OMEGA CDMA Modem controls which of these connectors is enabled (refer to

Page 14

Image 14
Contents Omega Cdma Modem User’s Guide Important Notice FCC Part 15 EMI Statement FCC Radiation Exposure StatementFCC ID N7NSB555 Contents Chapter Introduction ModelsIntroduction FeaturesOptions Hardware Features InstallationType II Omega Cdma Modem Type II Omega Cdma Modem with Marwell Socket Adapter Chapter Installation Installation SummaryUnpacking Your Hardware Obtaining Cellular Telephone ServiceAT Commands Items Supplied by the UserAttaching Mounting Feet stand-alone Omega Cdma Modem Installing the Optional 8-Port RS-232 ModulePower Supply Connections Setting the Omega DIP Switch Omega Cdma Modem Switch Settings DescriptionAttaching a DTE Cable DTR Dial EnableAT Commands DTE Baud Rate Switch Baud Rate bps OFFDCD OUT RTS TXD CTS RXD TX+ OUT RX+Configuring the Omega Cdma Modem Powering-up the ModemCall Answer Testing LEDs LEDs Indicating Modem Control Signals SW5 onDTE Signal LEDs Indicating Rssi SW5 OFFChapter Troubleshooting Problem SolutionAppendix a AT Commands Table A-1. Basic AT Commands Parameter Description CommandString default is 2 seconds Table A-3. Basic Action Commands Parameter DescriptionCLIENT? ResetCLIENT= DTRAT Command Parameter Description ~NAMVAL= ~NAMLCK~NAMVAL?0 Write Account Activation DataAT Command Line Syntax Table A-6. Telenetics-Proprietary CommandsResult Codes Only until the next reset or power off Using S-RegistersAT Commands Table A-7. Result Codes Number Word Description Page Installation Appendix B Installing the 8-port RS-232 ModuleVerifying Package Contents Installing the 8-port RS-232 Module Eight-Port Module PortsLimited Product Warranty Return Merchandise Authorization RMA Procedure