Telenetics CDMA Client=, Client?, Dtr?, Hip, Ipr?, Lip?, Loop, Lpass?, Luser?, Mac?, Mru?

AT Commands

Table A-4. Cellular CDMA Commands

AT Command	Parameter	Description
*?		Display list of OMEGA commands.
*CLIENT=	0	Disable Client mode.
	1	Enable Client mode.
*CLIENT?		Display Client mode activation.
*D= [string]		Set auto dialup string.
*D?		Display auto dial-up string.
*DIP [xxx.xxx.xxx.xxx]		Connect to given IP address.
*DTR	1	Enable DTR dialing.
	0	Disable DTR dialing.
*DTR?		Display DTR dialing activation.
*F		Restore the default OMEGA configuration.
*H		Hang up the modem connection.
*HIP		Hang up the active IP connection.
*I		Display the controller firmware version.
*IPR= [baud]		Set the controller-transceiver baud rate.
*IPR?		Display the controller-transceiver baud rate.
*LIP= [xxx.xxx.xxx.xxx]		Set the local IP address.
*LIP?		Display the local IP address.
*LOOP		Enter loopback mode.
*LPASS= [string]		Set the local password.
* LPASS?		Display the local password.
*LUSER= [string]		Set the local username.
*LUSER?		Display the local username.
*MAC= [string]		Set the controller MAC address or telephone number.
*MAC?		Display the controller MAC address or telephone number.
*MRU= [number]		Set the Point-to-Point Protocol (PPP) Maximum Receive
		Unit (MRU).
*MRU?		Display the PPP MRU.
*NETSTAT		Display network statistics.
*PING= [xxx.xxx.xxx.xxx]		Ping the specified IP address.
*PORT= [number]		Set the TCP and UDP listen port.
*PORT?		Display the TCP and UDP listen port.
*PPP=	1	Enable PPP.
	0	Disable PPP.
*PPP?		Display PPP activation.
*R= [secs]		Set the transceiver re-registration interval.
*R?		Display the transceiver re-registration interval.
*RESET		Restart the system.
*RIP= [xxx.xxx.xxx.xxx]		Set the remote IP address.
*RIP?		Display the remote IP address.

Page 22