SIIG 133, 100 Pro user manual Device Connection, Installing the board

User's Manual

Note: Hold the board by its external edges only. Try to avoid touching the components, connectors or pins.

Figure 2-1: Installing the board

2-2 Device Connection

The UltraATA 133/100 Pro is a dual channel Ultra ATA/133 controller that supports up to four IDE hard disk drives or CD-R/ RW drive. If you plan to use the second IDE channel (IDE2), you will need to purchase another 40-pin/80-wire Ultra ATA ribbon cable.

In order to achieve high-speed data transfer, a 40-pin/80-wire Ultra ATA ribbon cable is recommended. Also, do not mix Ultra ATA/133 hard disk with slower CD-R/RW drive on the same IDE channel.

1. Install hard disk drive(s) in chassis.

2-2